Skip to main content

#4 단계의 변경 사항

Arthur Shi- 에 의해 수정

편집 승인됨 에 의해 Arthur Shi

삭제되었습니다
추가
변경 사항이 없습니다

스텝 라인

[* icon_caution] Be careful not to damage the connector when performing this step.
[*
black] Use the point of a spudger or your fingernail to lift off the connector that holds the screen in place.
[* black] Lift off the display assembly completely
pry up and place it off todisconnect the side.
[* icon_reminder] Gently scrape any remaining adhesive
interconnect cable from your phone. Use a small amount of high concentration isopropyl alcohol (at least 90%) to clean the frame and prep it forbottom daughterboard.
[* icon_note] You can leave
the new screen adhesive.
[* icon_reminder] The replacement adhesive should only be applied
interconnect cable attached to the edges ofdaughterboard via the frame, but may come with the center filled in.
[* black] To
adhesive, or you can completely remove the unnecessary center section of the adhesive strip, carefully peel away the perforated rectangle in middle of the white backing. At the same time, peel up the black adhesive underneath the white backing.
[* icon_note] Only adhesive for the edges of the frame should remain
it.
[* icon_caution] Be careful not to damage the connector when performing this step.
[*
black] Use the point of a spudger or your fingernail to lift off the connector that holds the screen in place.
[* black] Lift off the display assembly completely
pry up and place it off todisconnect the side.
[* icon_reminder] Gently scrape any remaining adhesive
interconnect cable from your phone. Use a small amount of high concentration isopropyl alcohol (at least 90%) to clean the frame and prep it forbottom daughterboard.
[* icon_note] You can leave
the new screen adhesive.
[* icon_reminder] The replacement adhesive should only be applied
interconnect cable attached to the edges ofdaughterboard via the frame, but may come with the center filled in.
[* black] To
adhesive, or you can completely remove the unnecessary center section of the adhesive strip, carefully peel away the perforated rectangle in middle of the white backing. At the same time, peel up the black adhesive underneath the white backing.
[* icon_note] Only adhesive for the edges of the frame should remain
it.

이미지 1

이전 버전

새로운 버전

이미지 2

이전 버전

새로운 버전