메인 콘텐츠로 스킵하기

#6 단계의 변경 사항

Arthur Shi- 에 의해 수정

편집 승인됨 에 의해 Arthur Shi

삭제되었습니다
추가
변경 사항이 없습니다

스텝 라인

[* red] Disconnectblack] Flip the phone over.
[* black] Push an opening pick slowly and firmly down the right edge of
the battery by using a spudger(which should be warm). Slide it slightly back and forth to pry upslice through the battery connector.
[* icon_note] A large daughterboard interconnect
adhesive.
[* icon_caution] Be careful not to snag the white antenna
cable coversrunning along the battery. Before removingedge of the battery,battery while you will need to detach this cable and move it out ofare push down on the way.
[* orange] Peel back
pick.
[* icon_note] If you are having a hard time getting
the tape coveringopening pick under the lower end ofbattery, heat and re-apply an iOpener as instructed in the cable to reveal where it connectsprevious step.
[* icon_note] You can also apply some high concentration isopropyl alcohol
to the daughterboard. Then, use your spudgeredge in order to pry uphelp weaken the cable and disconnect itadhesive.
[* black] If desired,Once you can dohave loosened the same at the top endright side of the cablebattery from the case, leave an opening pick in place to detach and remove it completely, or you may simply bend the cable gently out of the way while you removeprevent the batteryadhesive from re-adhering.
[* red] Disconnectblack] Flip the phone over.
[* black] Push an opening pick slowly and firmly down the right edge of
the battery by using a spudger(which should be warm). Slide it slightly back and forth to pry upslice through the battery connector.
[* icon_note] A large daughterboard interconnect
adhesive.
[* icon_caution] Be careful not to snag the white antenna
cable coversrunning along the battery. Before removingedge of the battery,battery while you will need to detach this cable and move it out ofare push down on the way.
[* orange] Peel back
pick.
[* icon_note] If you are having a hard time getting
the tape coveringopening pick under the lower end ofbattery, heat and re-apply an iOpener as instructed in the cable to reveal where it connectsprevious step.
[* icon_note] You can also apply some high concentration isopropyl alcohol
to the daughterboard. Then, use your spudgeredge in order to pry uphelp weaken the cable and disconnect itadhesive.
[* black] If desired,Once you can dohave loosened the same at the top endright side of the cablebattery from the case, leave an opening pick in place to detach and remove it completely, or you may simply bend the cable gently out of the way while you removeprevent the batteryadhesive from re-adhering.

이미지 1

이전 버전

새로운 버전

이미지 2

이전 버전

새로운 버전

이미지 3

이전 이미지가 없습니다

추가