#18단계의 변경 사항
Jeff Suovanen- 에 의해 수정
편집 승인됨 완료자 Jeff Suovanen
- 이전
- 이후
- 변경 사항이 없습니다
단계 라인
[* black] Lift and remove the battery. |
[* icon_reminder] Before installing your new battery, remove all the old adhesive from the MacBook Pro's case. |
[* black] With a little luck, you can slowly pull out each strip of adhesive with your fingers. |
[* black] Otherwise, soak each |
[* black] Otherwise, soak each |
[* black] Mop up any remaining adhesive remover and give your MacBook Pro a few minutes to air dry. |
[* icon_reminder] The replacement battery included in your iFixit kit comes with adhesive pre-installed. One cell at a time, peel off the film covering the adhesive, and carefully position the battery cell before pressing it into place. |
[* black] Calibrate your battery before using it: allow it to drain overnight, then charge it to 100% and drain it again until your MacBook Pro shuts down automatically. Charge it again and use it normally. |
[* icon_caution] If you notice any unusual behavior or problems after installing your new battery, you may need to [https://support.apple.com/en-gb/HT201295|reset your MacBook Pro's SMC|new_window=true]. |