#18단계의 변경 사항
Jeff Suovanen- 에 의해 수정
편집 승인됨 완료자 Jeff Suovanen
- 이전
- 이후
- 변경 사항이 없습니다
단계 라인
[* black] Lift and remove the battery. |
[* icon_reminder] Before installing your new battery, remove all the old adhesive from the MacBook Pro's case. |
[* black] With a little luck, you can slowly pull out each strip of adhesive with your fingers. |
[* black] Otherwise, soak each strip of adhesive with a bit of adhesive remover for 2-3 minutes, and then scrape it out with a plastic tool. This can take quite a bit of work, so be patient. |
[* black] Mop up any remaining adhesive remover and give your MacBook Pro a few minutes to air dry. |
[* icon_reminder] The replacement battery included in your iFixit kit comes with adhesive pre-installed. Test the battery's fit and alignment carefully before peeling off the film covering the adhesive, and then press each cell firmly into place. If any additional films/liners are present that weren't on your original battery, remove them now. |
[* black] Calibrate your |
[* black] Calibrate your |
[* icon_caution] If you notice any unusual behavior or problems after installing your new battery, you may need to [https://support.apple.com/en-gb/HT201295|reset your MacBook Pro's SMC|new_window=true]. |