주요 콘텐츠로 건너뛰기

기기를 고치세요

수리할 권리

부품 & 도구

#8단계의 변경 사항

Adam O'Camb- 에 의해 수정

편집 승인됨 완료자 Adam O'Camb

이전
이후
변경 사항이 없습니다

단계 라인

[* icon_reminder] Before replacing your rear glass you will need to remove the old adhesive.To reinstall the back cover:
[* black] UseFirst use tweezers to remove thepeel away any remaining adhesive residue onfrom both the glass back cover and framethe phone's chassis.
[* black] CleanThen, clean the joining edgesadhesion areas with high concentration isopropyl alcohol (at least 90%), then apply90%) and a lint-free cloth. Swipe in one direction only, not back and forth. This will help prep the surface for the new adhesive.
[* black] Be sure to turn on your phone and test your repair before installing new adhesive and resealing the phone.
[* icon_note] Replacement adhesive comes in a pre-cut sheet to match the exact contours of the back cover. If that's not available, you can use a high-bond double-sided tape, such as [product|IF317-072|Tesa 61395|new_window=true]. Be aware that this leaves gaps that are vulnerable to liquid intrusion.
[* black] After installing the rear cover, apply strong, steady pressure to your phone for several minutes to help the adhesive form a good bond, such as by placing it under a stack of heavy books.
[* icon_note] If desired, you may reinstall the back cover without replacing the adhesive. Remove any large chunks of adhesive that might prevent the back cover from sitting down flush. After installation, heat the back cover and apply pressure to secure it. It won't be waterproof, but the glue is usually more than strong enough to hold.
[* icon_reminder] Before replacing your rear glass you will need to remove the old adhesive.To reinstall the back cover:
[* black] UseFirst use tweezers to remove thepeel away any remaining adhesive residue onfrom both the glass back cover and framethe phone's chassis.
[* black] CleanThen, clean the joining edgesadhesion areas with high concentration isopropyl alcohol (at least 90%), then apply90%) and a lint-free cloth. Swipe in one direction only, not back and forth. This will help prep the surface for the new adhesive.
[* black] Be sure to turn on your phone and test your repair before installing new adhesive and resealing the phone.
[* icon_note] Replacement adhesive comes in a pre-cut sheet to match the exact contours of the back cover. If that's not available, you can use a high-bond double-sided tape, such as [product|IF317-072|Tesa 61395|new_window=true]. Be aware that this leaves gaps that are vulnerable to liquid intrusion.
[* black] After installing the rear cover, apply strong, steady pressure to your phone for several minutes to help the adhesive form a good bond, such as by placing it under a stack of heavy books.
[* icon_note] If desired, you may reinstall the back cover without replacing the adhesive. Remove any large chunks of adhesive that might prevent the back cover from sitting down flush. After installation, heat the back cover and apply pressure to secure it. It won't be waterproof, but the glue is usually more than strong enough to hold.