주요 콘텐츠로 건너뛰기
도움말
3단계 편집 중 —

단계 유형:

끌어서 재배열 합니다

Using a 2mm hex driver, remove the two small screws that hold the pistol grip plate in place.

After removing the plate, you will see the motor and two wires attached to it. Carefully lift the wires up off of the motor terminals. Note the orientation of the motor and the wires, you will need to re-install them the same way later on.

Pull the motor out of the pistol grip.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.