주요 콘텐츠로 건너뛰기
도움말
7단계 편집 중 —

단계 유형:

끌어서 재배열 합니다

Now with the two shells together check to see if the gear axles are set into the bearings. Then check to see if the anti-reversal latch is out of place.

If the two half's still don't quit meet together perfectly check the piston putting a 3mm hex driver down the air-nozzle and push the piston back. This should set the piston into place.

If everything checks out you can begin screwing the to half's together starting with the center screw and then the two major screws, one on either side of the gearbox.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.