주요 콘텐츠로 건너뛰기

기기를 수리하세요

수리할 권리

상점

도움말
2단계 편집 중 —

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 포함하는 안내서 6개에 영향을 미칩니다.

단계 유형:

끌어서 재배열 합니다

Use a suction handle to lift the back cover and create an opening pick to get in the gap.

Since the back cover is also slightly curved at the edges you want to insert the opening pick at a lower angle from underneath.

Start at the middle of the side and cut the adhesive while pulling up with the suction handle.

Be careful not to lever the opening pick too much to avoid breaking the back cover. Rather pull with the suction handle and use the pick for cutting the adhesive.

Move the pick towards the bottom corner and leave it there to keep the adhesive from resealing to the case.

Use another pick and move it to the top corner.

If it's getting harder to move the pick you might need to reheat the iOpener and apply it to the back cover again.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.