Skip to main content
도움말
8단계 편집 중 —

알림: 귀하는 지금 열람하신 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 사용하는 모든 5 안내서에 영향을 미칩니다.

단계 유형:

끌어서 재배열 합니다

Use the flat end of a spudger (or an opening tool) to pry the touch screen cable connector up off the upper logic board.

Now that the front panel is out, check it for damage. If the plastic surround is not flush with the front face of the glass panel, gently peel it off and stick it down.

Be careful not to scratch the front panel on the underside of the black portions, as the scratches will be visible once the device is reassembled.

Be sure to clean both the face of the display and the inner surface of the front panel, as any dust or fingerprints will be trapped inside the Touch once it is fully reassembled.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.