주요 콘텐츠로 건너뛰기
도움말
7단계 편집 중 —

단계 유형:

끌어서 재배열 합니다

Remove the two screws underneath the GPS connector.

Desolder the GPS connector.

The GPS antenna is a thru-hole-mounted device. You must apply heat to each soldered pin individually and pull them out of the holes while the solder is molten.

The solder material, pins, and any surrounding material will get VERY hot while melting the connections. Do not touch any metal parts during the desoldering process and give the device time to cool off once you’re finished. It may also be good to take breaks so that the electronics aren’t kept hot for extended periods of time.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.