4 단계 번역중
4 단계
Sealing the USB connector
-
Connect the flex PCB back to the main board.
-
Reassemble the watch stopping before screwing the lid back.
-
Add hot glue to the base of the USB connector filling the watch case's cavity. Be careful not to put hot glue inside the connector.
-
While the glue is still hot, put the red rubber seal back on top.
-
Screw the lid back.
귀하의 기여는 오픈 소스 Createive Commons 라이선스 하에 허가되었습니다.