주요 콘텐츠로 건너뛰기
도움말
1단계 편집 중 —

단계 유형:

끌어서 재배열 합니다

Use the pointed end of a spudger to disconnect the front camera's press connector from its socket.

Be careful to pry only under the edge of the connector, and not under the socket itself. If you pry under the socket, you will separate it from the circuit board.

To reconnect, align the connector carefully over its socket and press down with your fingertip—first at one side, then the other—until it clicks into place.

Do not press down on the middle until the connector is fully seated—if it's misaligned, the connector can bend, causing permanent damage.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.