주요 콘텐츠로 건너뛰기
도움말
6단계 편집 중 —

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 사용하는 안내서에 영향을 미칩니다.

단계 유형:

끌어서 재배열 합니다

You need to have lots of patience in this procedure. Take your time.

Using an infrared thermometer heat the surface to 170-180° F (roughly 70-80° C). This will loosen the glue but not damage the electronics.

Hold the gun at about 3 inches from your phone (in this picture it looks like its right on top). With the heat gun set to low, heat up the borders for about 3 to 5 minutes depending on the strength of your heat gun.

You must be careful when using the heat gun on this device. If the device is heated up too much then it may melt the digitizer and cause discoloration. If you start to see any discoloration then shut off the gun immediately.

If you are working with a hair dryer, it might take up to 1 hour.

This melts the glue that holds the glass to the frame and to the display. The glass is glued to them.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.