주요 콘텐츠로 건너뛰기
도움말
4단계 편집 중 —

단계 유형:

끌어서 재배열 합니다

If you have already used a fuse resistor to complete the previous step, you may omit this step.

Insert and solder the parallel 10 ohm 1/4 watt resistors to the F1 socket.

The resistors should be laid out on the top side of the circuit board and the leads should poke out from the underside. The orientation of the resistor does not matter.

The 1/4 watt resistors shown in the picture are used to depict what parallel resistors should look like.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.