메인 콘텐츠로 스킵하기
도움말
3단계 편집 중 —

알림: 귀하는 지금 열람하신 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 사용하는 모든 2 안내서에 영향을 미칩니다.

단계 유형:

끌어서 재배열 합니다

Due to variations between iBook G4 models, your heatsink may have either 5 or 6 screws. We've noted all possible positions for screws in the step below. If there's no screw to remove, then skip to the next screw. Be sure that you remove all necessary screws before attempting to remove the heat sink.

Remove the following 6 screws and 3 nuts from the heat sink:

One 2 mm Phillips extending from a finger on the left edge of the heatsink and adjacent the firewire port (not present on some models)

Three 3 mm Phillips from around the fan (some models may only have 2 screws).

One 3.5 mm Phillips on the left side of the heat sink (not present on some models).

One 4.5 mm Phillips at the top right corner of the heat sink.

One 6 mm Phillips at the lower left corner of the heat sink.

One 4 mm nut from the right side of the heat sink.

Two 4 mm screw nuts with attached springs from either side of the heat sink.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.