Skip to main content
도움말
5단계 편집 중 —

단계 유형:

끌어서 재배열 합니다

The factory bolt is a bit larger in diameter than the half-circle connector will allow -- unless it is expanded! So insert a needle-nose plier into the center for the connector and then spread it apart in order to accommodate the bolt.

Route the bolt through the horn's mounting hole.

Screw the bolt / ground wire / horn assembly into the factory mounting hole.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.