주요 콘텐츠로 건너뛰기

기기를 고치세요

수리할 권리

부품 & 도구

도움말
3단계 편집 중 —

단계 유형:

끌어서 재배열 합니다

Remove the cable ribbon that is attached to the motherboard.

And voila! You have successfully taken out the circuit board.

And here we see the solder that keeps the RC components strapped into the board. In order to get them off and put them back on, you'll need a soldering iron, wick, and solder itself.

If you don't know how to solder properly, there are plenty of helpful guides online, such as this one. Make sure to remove the solder all the way before removing the RC jacks, otherwise you could hurt the board.

Now you just have to take off the RC components, place the news ones in, and solder them into the board (again using a soldering guide if you need to).

Good work! Now celebrate by listening to your favorite movie!

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.