Smaller press-fit (or "pop") connectors may require a simple flick with a plastic opening tool, spudger, or fingernail.
Place the tip of your tool under the edge of the connector, and pry the connector straight up from its socket.
Be very careful to pry only under the edge of the connector, and not under the socket itself. If you pry under the socket, you will separate it from the circuit board, which requires specialized microsoldering skills and equipment to repair.
To reconnect, align the connector carefully over its socket and press down with your fingertip—first at one side, then the other—until it clicks into place.
Do not press down on the middle until the connector is fully seated—if it's misaligned, the connector can bend, causing permanent damage.
귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.
아래에 새로운 줄 삽입
위에 새로운 줄 삽입
현재 줄 들여쓰기
현재 줄 내어쓰기
현재 줄 삭제
다음 단계로 이동.
이전 단계로 이동.