메인 콘텐츠로 스킵하기
도움말
1단계 편집 중 —

단계 유형:

끌어서 재배열 합니다

After removing the front bezel, you need to remove the 8ea 12mm T8 screws around the perimeter of the LCD

Rotate the iMac so the TOP EDGE is facing you and GENTLY lift the LCD up about 75mm (3in) and prop up the LCD with something NON CONDUCTIVE.

Lifting the LCD in this way exposes the rear of the PSU to allow access to the PSU connector. When the imac is connected to the mains (even if switched OFF) there is MAINS VOLTAGE on this board

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.