주요 콘텐츠로 건너뛰기
도움말
8단계 편집 중 —

단계 유형:

끌어서 재배열 합니다

Remove electronic strips on the right, bottom center, top center, and a cable on the left side of the input board.

Remove two screws shown in the second image. Remove the gray connector on top of the input board.

Next, use a flat head screwdriver to assist you in prying the right clip while simultaneously pulling up on the input board. Unclip the component from the logic board.

Note that there is a clip on both the left and right sides of the input board.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.