주요 콘텐츠로 건너뛰기
도움말
4단계 편집 중 —

단계 유형:

끌어서 재배열 합니다

1.) Take the good end of the existing wire and strip it.

2.) The interior wire, which is coated in white should be soldered on a square metal plate about one eighth inch square. This plate is opposite a small chip for reference.

3.) The braided wire coats the white interior wire, and is wrapped around it in two different directions. This wire should be peeled off and then twisted together.

4.) Then solder it in place opposite the chip and the other wire.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.