Skip to main content
도움말
1단계 편집 중 —

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 사용하는 모든 3 안내서에 영향을 미칩니다.

단계 유형:

끌어서 재배열 합니다

Place a piece of cloth or a similar soft material on a clean, flat surface. Place the device upside down on top of the fabric.

Open the Time Capsule by exposing the screws that hold the device together. The screws are concealed by the rubber base, which is the bottom surface of the device.

Use a heat gun or hair dryer to heat the rubber base, which softens the adhesive holding it on.

Starting in a corner, carefully lift the rubber base to prevent tearing. You can use a guitar pick or a small, plastic ruler to help separate the rubber from the metal.

Take your time to prevent tearing the adhesive. Ensure that you don't overheat the device.

If you tear some of the adhesive, don't worry. The existing adhesive is more than enough to allow the rubber base to stick back onto the unit during reassembly.

During reassembly, you can apply heat to the rubber base. This will enable the adhesive to flow and form a better bond with the device's metal casing.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.