주요 콘텐츠로 건너뛰기
도움말
4단계 편집 중 —

단계 유형:

끌어서 재배열 합니다

Before sliding the trigger button retainer back into the rails molded into the front cover, be sure that the cylindrical post attached to the #1 button is sitting flat on the green rubber electronic switch cover. Failure to do so may lead to problems with fit during reassembly, and may cause the controller to not recognize inputs from the #1 button during operation.

The trigger button assembly is properly installed when the lip on the trigger button retainer sits flat against the motherboard.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.