Skip to main content
도움말
17단계 편집 중 —

단계 유형:

끌어서 재배열 합니다

Route the wiring in the same manner the old switch wiring was routed, insert the switch into the steering column, and put back the ignition switch cover and screws.

Use the electrical tape to corral any of the loose wiring. Put all paneling back the way it was by following the above directions in reverse. Make sure that the rubber O-ring around the ignition switch is properly seated against the switch when putting back the lower steering wheel cover.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.