주요 콘텐츠로 건너뛰기
도움말
7단계 편집 중 —

알림: 귀하는 지금 열람하신 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 사용하는 모든 8 안내서에 영향을 미칩니다.

단계 유형:

끌어서 재배열 합니다

Insert the edge of an iPod opening tool under the steel mid plate near the bottom left corner of the Touch.

Pry upward to separate the plate from the adhesive securing it to the plastic inner case.

If the plate is still attached to the logic board re-warm the area to loosen the adhesive, then separate the plate from the logic board using the opening tool

Use extreme care, the speaker is under the area shown in photo. It is connected with very thin and short wires.

There is a very thin ribbon cable here that connects the volume and power buttons to the logic board. Try to work around this area like shown so not to rip the cable. Be sure to hold down this cable when lifting the plate. It could stick to the plate due to residual glue. It is extremely fragile.

This cable will tear very easily if you are not careful.

There is also adhesive under the area shown in red.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.