메인 콘텐츠로 스킵하기
도움말
12단계 편집 중 —

알림: 귀하는 지금 열람하신 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 사용하는 모든 11 안내서에 영향을 미칩니다.

단계 유형:

끌어서 재배열 합니다

Remove the 4.8 mm standoff screw near the headphone jack.

Standoff screws are best removed using an iPhone Standoff Screwdriver Bit and driver handle.

In a pinch, a small flathead screwdriver will do the job—but use extra caution to ensure it doesn't slip and damage surrounding components.

When reassembling the device, this standoff sets the height of the Wi-Fi shield removed in step 13. If not torqued down, the shield will be above the plane of the frame and the back will not slide into place in step 2. The shield should be flush with the headphone jack.

When reassembling the motherboard, ensure that its edge sits under the circled standoff, otherwise the screws will not fit.

When reassembling ensure that the small rubber spacer attached to the top of the motherboard is in place.

Without this part, the motherboard could damage the ribbon cables around it.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.