주요 콘텐츠로 건너뛰기
도움말
12단계 편집 중 —

알림: 귀하는 지금 열람하신 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 사용하는 모든 2 안내서에 영향을 미칩니다.

단계 유형:

끌어서 재배열 합니다

If using liquid adhesive remover, apply a few more drops under each of the final two, middle cells.

It may help to elevate one side of your MacBook Pro a few inches so that the adhesive remover flows in the correct direction, underneath the battery cells. You can use a sturdy book or foam block to prop up one side of your MacBook Pro while you work.

Allow 2-3 minutes for the adhesive remover to penetrate before you continue.

Gently folding the right-most battery cells out of the way, insert a plastic card under the right center cell.

Push the card in about half of its length to cut the adhesive holding the battery cell to the case.

Be sure to avoid the trackpad control board. Aim the card up toward the logic board, where the adhesive is.

Leave the card in place to keep the adhesive from re-sealing.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.