주요 콘텐츠로 건너뛰기
도움말
2단계 편집 중 —

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 사용하는 안내서에 영향을 미칩니다.

단계 유형:

끌어서 재배열 합니다

Twist the opening pick to fully dislodge the battery and remove it.

Do not reuse the battery after it has been removed, as doing so is a potential safety hazard. Replace it with a new battery.

To install a new battery and ensure that is is properly aligned:

Remove any remaining adhesive from the phone, and clean the glued areas with isopropyl alcohol and a lint-free cloth.

Lay the replacement battery in place, but do not apply adhesive yet. Resume re-assembly until the motherboard is in place (STEP 18).

Apply new pre-cut adhesive or double-sided tape onto the phone frame, around the perimeter of the battery compartment, but not in the rectangular cutout in the center (which is actually the back side of the display).

Temporarily connect the battery connector to the motherboard to ensure proper battery alignment.

Press the battery firmly into place for 5-10 seconds. Disconnect the battery and resume re-assembly.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.