주요 콘텐츠로 건너뛰기
도움말
3단계 편집 중 —

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 포함하는 안내서 16개에 영향을 미칩니다.

단계 유형:

끌어서 재배열 합니다

Pull up on the exposed clear plastic tab to peel the battery off the adhesive securing it to the iPhone.

If the tab breaks before the battery is freed, apply a few drops of high concentration (over 90%) isopropyl alcohol under the edge of the battery. Wait about one minute for the alcohol solution to weaken the adhesive. Carefully slide a spudger under the battery tab to release the adhesive.

Prying in other places may cause damage. Don't try to forcefully lever the battery out. If needed, apply a few more drops of alcohol to further weaken the adhesive. Never deform or puncture the battery with your pry tool.

If there's any alcohol solution remaining in the phone, carefully wipe it off or allow it to air dry before installing your new battery.

Remove the battery.

If your replacement battery came in a plastic sleeve, remove it before installation by pulling it away from the the ribbon cable.

Before reassembly, clean metal-to-metal contact points with a de-greaser such as windex. The oils from your fingers have the potential to cause wireless interference issues.

Perform a hard reset after reassembly. This can prevent several issues and simplify troubleshooting.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.