Andis Master Clippers Motor/Coil Assembly Replacement

영어

한국어

4 단계 번역중

4 단계

Using the wire stripper, strip the ends of each wire approximately 1-2 cm to reveal enough wire to twist back together with new motor's wires.
Next, using the wire cutter, cut the {Positive & Negative} wires that are heading from the Coil Assembly to the Attached power cord. Cut approximately half way between the two ends of both wires.
Reminder: Be sure to keep track of the corresponding wires and their locations to match when you insert the new motor.
After you cut the old Coil Assembly's wires, remove it completely, and replace it with new one.

귀하의 기여는 오픈 소스 Createive Commons 라이선스 하에 허가되었습니다.