메인 콘텐츠로 스킵하기
도움말
2단계 편집 중 —

단계 유형:

끌어서 재배열 합니다

Gently push the THIN wires through the rubber end cap to create a bit of a loop on the rear of the assembly.

Using a plastic pry tool you can pop the rubber end cap out and then lift the thin wires out of the groove in the rear of the CCFL assembly

Note the thin wires are held in the groove by a small amount of adhesive.

Run the pry tool the length of the assembly and free the wires all the way to the other end cap

gently pop the rubber end cap out of the assembly

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.