주요 콘텐츠로 건너뛰기
도움말
3단계 편집 중 —

알림: 귀하는 지금 열람하신 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 사용하는 모든 5 안내서에 영향을 미칩니다.

단계 유형:

끌어서 재배열 합니다

Use a suction cup or an iSclack to pull up on the glass and create a slight gap between the glass and the metal frame.

If your display is badly cracked, a suction cup may not adhere. It may help to first cover the display with a layer of packing tape. Alternatively, you can superglue your suction cup to the display.

Insert an opening pick into the gap.

There are tabs on the upper right side and upper left side where it is easier to get a tool under the display.

Slide an opening pick around the sides and bottom of the display to cut the adhesive. Apply more heat as needed.

The tape is much thinner on the bottom edge than the other three sides. Do not push the tool in too far or you will damage the screen permanently.

Work carefully—the glass is thin and will crack easily if you try to force it.

Separate the top edge last. There are antennas on both sides, so be careful not to damage them. If needed, you can use a bit of isopropyl alcohol to help weaken the adhesive.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.