주요 콘텐츠로 건너뛰기

기기를 고치세요

수리할 권리

부품 & 도구

도움말
4단계 편집 중 —

단계 유형:

끌어서 재배열 합니다

Place the leads of the resistor through the holes on either side of the rectangle marked R1 on the circuit board.

Resistors do not have to be installed in a particular orientation. Either lead can go into either hole.

Turn the board over so that the copper traces are facing up and the resistor leads are pointing straight up in the air, as seen in the second picture.

You may also bend the leads outward to hold the resistor in place, but this is not necessary. As per NASA guidelines, any angle up to 30° down from vertical is acceptable.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.