주요 콘텐츠로 건너뛰기

기기를 고치세요

수리할 권리

부품 & 도구

도움말
7단계 편집 중 —

단계 유형:

끌어서 재배열 합니다

Use the same method above to solder the second resistor lead to the circuit board.

After soldering a joint, if you are going to put the soldering iron down, be sure to place it back in its stand to prevent burning yourself or anything around you.

Cut the extra lengths of the resistor leads with a pair of wire cutters. NASA workmanship standards state that any length up to 2.29 mm is acceptable.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.