주요 콘텐츠로 건너뛰기

기기를 고치세요

수리할 권리

부품 & 도구

도움말
23단계 편집 중 —

단계 유형:

끌어서 재배열 합니다

Locate the semi-circle labeled T1 and insert the three leads through the holes.

Make sure that you line up the flat part of the transistor with the flat edge of the semi-circle on the board. The two end leads fit into the holes on the ends of the flat part of the drawing. The middle lead will need to be bent so that it feeds through the hole closest to the T1.

Solder the three leads to the board and cut the excess off the leads.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.