주요 콘텐츠로 건너뛰기

기기를 고치세요

수리할 권리

부품 & 도구

도움말
8단계 편집 중 —

단계 유형:

끌어서 재배열 합니다

We all make mistakes, especially when trying something new. Soldering is no exception, so here's what to do when one of your soldered joints comes out less than ideal.

Lay a strand of desoldering braid over the solder in question. Press the tip of the soldering iron firmly onto the desoldering braid. This will heat up both the solder and the braid.

Do not hold the braid close to the solder point while using it—it gets very hot and can burn you.

Be careful not to lay the desoldering braid across the fiberglass circuit board. As the braid heats up, it could leave marks in the board.

The solder should flow from the joint to the desoldering braid. After the solder flows into the braid, remove it and the soldering iron from the board. You should now have a clean contact to start over with. Use wire cutters to cut off the used end of the desoldering braid.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.