Skip to main content
도움말
1단계 편집 중 —

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 사용하는 모든 27 안내서에 영향을 미칩니다.

단계 유형:

끌어서 재배열 합니다

Remove the following screws securing the antenna plate to the mini:

Two 6.6 mm T8 Torx screws

Two 5.0 mm T8 Torx or 2.0 mm Hex screws (either screwdriver will work)

When putting back together:

It can be difficult to get the hard drive seated correctly such that the antenna plate fits in place correctly. If the screw holes don't line up with those on the hard drive, make sure that the two pins that are in the back of the hard drive are properly seated in the holes at the back of the case, above the housing for the second hard drive.

The antenna attaches directly to the hard drive (red markers), therefore attaching the antenna can move the hard drive around and loosen the connection of the hard drive cable to the logic board.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.