주요 콘텐츠로 건너뛰기
도움말

알림: 귀하는 지금 열람하신 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 사용하는 모든 4 안내서에 영향을 미칩니다.

단계 유형:

끌어서 재배열 합니다

Whether installing a replacement display assembly or re-using the existing display assembly, note the following:

Carefully straighten the digitizer and LCD data cables, and feed them through the slot cut in the outer case.

The middle photo shows the digitizer cable being correctly fed through to its full length.

This photo shows the display assembly being installed incorrectly, with too much slack in the digitizer cable, which then forms a bend/loop that gets caught in the slot. The third photo also shows this loop.

If the digitizer cable has been installed incorrectly, it will not reach its socket on the logic board. Do not attempt to pull it through by force, or it will be cut by the sharp edge of its slot in the enclosure. Remove the display assembly, straighten the cable, and re-feed the cable through completely and correctly.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.