주요 콘텐츠로 건너뛰기
도움말
11단계 편집 중 —

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 포함하는 안내서 2개에 영향을 미칩니다.

단계 유형:

끌어서 재배열 합니다

For the last section, battery leads will be soldered to surface-mount solder pads. These type of joints are harder to solder because the lead has no solid anchor point (such as a thru-hole) to hold it in place during soldering.

To de-solder the joint, place a solder wick on top of the existing solder ball and press down on the solder wick with the soldering iron.

Once the solder melts and flows into the wick, remove the wick from the joint.

Repeat the same procedure on the remaining leads.

When a section of solder wick is saturated with solder, it should be trimmed and discarded.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.