Skip to main content
Help
16단계 편집 중 —

알림: 귀하는 지금 열람하신 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 사용하는 모든 6 안내서에 영향을 미칩니다.

단계 유형:

끌어서 재배열 합니다

Remove the battery.

Before installing your new battery, remove all the old adhesive from the MacBook Pro's case.

With a little luck, you can slowly pull out each strip of adhesive with your fingers.

Otherwise, soak each section of adhesive with a bit of adhesive remover for 2-3 minutes, and then scrape it out with an opening pick or one of the other tools in your kit. This can take quite a bit of work, so be patient.

Mop up any remaining adhesive remover and give your MacBook Pro a few minutes to air dry.

The replacement battery included in your iFixit kit comes with adhesive pre-installed. Test the battery's fit and alignment carefully before peeling off the film covering the adhesive, and then press each cell firmly into place. If any additional films/liners are present that weren't on your original battery, remove them now.

Calibrate your newly installed battery: charge it to 100%, and keep charging it for at least 2 more hours. Unplug and use it normally to drain the battery. When you see the low battery warning, save your work, and keep your laptop on until it goes to sleep due to low battery. Wait at least 5 hours, then charge your laptop uninterrupted to 100%.

If you notice any unusual behavior or problems after installing your new battery, you may need to reset your MacBook Pro's SMC.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.