주요 콘텐츠로 건너뛰기

기기를 고치세요

수리할 권리

부품 & 도구

도움말
2단계 편집 중 —

알림: 귀하는 지금 열람하신 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 사용하는 모든 5 안내서에 영향을 미칩니다.

단계 유형:

끌어서 재배열 합니다

When the back panel is warm to the touch, apply a suction cup as close to the heated edge of the phone as you can while avoiding the curved edge.

The suction cup will not make a good seal on the curved portion of the glass.

If the phone's back cover is cracked, the suction cup may not stick. Try lifting it with strong tape, or superglue the suction cup in place and allow it to cure so you can proceed.

Lift on the suction cup and insert an opening pick under the rear glass.

The rear glass can break if you use too much force or attempt to pry with metal tools.

Due to the curved glass, you will be pushing up, rather than inserting parallel to the plane of the phone.

If you have trouble, apply more heat to further soften the adhesive, and try again. The adhesive cools very fast, so you may need to heat it repeatedly.

Optionally, once the pick is inserted, you can add a few drops of isopropyl alcohol into the gap to help weaken the adhesive in the following steps.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.