Skip to main content
도움말
7단계 편집 중 —

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 사용하는 모든 14 안내서에 영향을 미칩니다.

단계 유형:

끌어서 재배열 합니다

The fingerprint sensor cable connects the phone to the rear glass near the main camera. The cable is very short and should disconnect as the rear glass is removed.

As you lift the glass, peek in to be sure the orange cable with a blue connector has disconnected.

Use the opening picks to slice through any remaining adhesive and open the phone slightly.

If the fingerprint sensor cable seems snagged or stays taut do not open the phone any further. Disconnect the connector with the point of a spudger before proceeding.

During reassembly, in order to reconnect the fingerprint sensor cable, first angle the back cover into position until the cable connector lines up perfectly over its socket. Then, use the flat end of your spudger to gently snap the connector into place by pressing it straight down.

Remove the glass from the phone.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.