주요 콘텐츠로 건너뛰기
도움말
8단계 편집 중 —

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 포함하는 안내서 14개에 영향을 미칩니다.

단계 유형:

끌어서 재배열 합니다

To install a new back cover:

Use tweezers to peel away any remaining adhesive from the phone's chassis. Then clean the adhesion areas with high concentration isopropyl alcohol (at least 90%) and a lint-free cloth to prep the surface for the new adhesive.

Peel the adhesive backing off of the new rear glass, carefully line up one edge of the glass against the phone chassis, and firmly press the glass onto the phone.

Follow this guide to reinstall the old back cover, or to install a back cover without pre-installed adhesive.

Be sure to turn on your phone and test your repair before installing new adhesive and resealing the phone.

If desired, you may reinstall the back cover without replacing the adhesive. Remove any large chunks of adhesive that might prevent the back cover from sitting down flush. After installation, heat the back cover and apply pressure to secure it. It won't be waterproof, but the glue is usually more than strong enough to hold.

You may also need to transfer the camera bezel to your new part. If that's the case, follow our camera bezel replacement guide.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.