주요 콘텐츠로 건너뛰기
도움말
5단계 편집 중 —

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 사용하는 안내서에 영향을 미칩니다.

단계 유형:

끌어서 재배열 합니다

Gently lift up on the top in order to separate it from the half that it is attached to.

Be gentle when lifting the top as there are cables soldered into place that run down the length of the device. Don't jerk it out, NO PUN INTENDED, as you may damage these wires or their solder points.

Pull the plastic piece out from its retaining slot.

At this point, the PCB may make a slight popping sound. It didn't break! It simply popped out of it's retaining slot as well as you removed the plastic piece.

Remember, be gentle with the grey plastic piece. It's still attached to the bottom electronics via the 2 static cords. DO NOT over stretch these cords.

Remove the single screw that's hidden underneath the top/power button unit.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.