주요 콘텐츠로 건너뛰기
도움말
4단계 편집 중 —

알림: 귀하는 선행 작업 안내서를 편집하고 계십니다. 변경된 사항들은 이 선행 작업 단계를 사용하는 안내서에 영향을 미칩니다.

단계 유형:

끌어서 재배열 합니다

Photos depict where to desolder the power cables connection points. Remove any hot glue that may be holding down the cables. These devices are a little seasoned so the glue should not be hard to remove by hand.

I found it easiest to use the base to prop up the body, the half of the housing that the electronics typically reside in, in order to get a good angle at removing the solder. I'm sure it can be done on its side but lets work smarter, not harder here.

Remember to pull the ground cable completely through the PCB. We will re-thread it back through during the reassembly process.

Remember, the base is not attached at this point. Don't knock the Ionic Breeze over while it's in an upright position with it's internal components exposed.

귀하의 기여는 오픈 소스 Creative Commons 인가 하에 허가되었습니다.