소개

Replacing the plastic bottom case.

  1. Use a coin to rotate the battery locking screw 90 degrees clockwise.
    • Use a coin to rotate the battery locking screw 90 degrees clockwise.

    • Lift the battery out of the computer.

    댓글 쓰기

  2. Use a pin to remove the three rubber feet from the lower case.
    • Use a pin to remove the three rubber feet from the lower case.

    댓글 쓰기

    • Remove the three newly-revealed Phillips screws.

    댓글 쓰기

    • Use a spudger or small flathead screwdriver to pry up the three metal rings that housed the rubber bumpers.

    댓글 쓰기

    • Remove the three hex screws using a T8 Torx screwdriver.

    • The screw in the center is shorter than the other two.

    댓글 쓰기

    • Remove the two Phillips screws on either side of the battery contacts.

    댓글 쓰기

    • Breathe deeply. Trying times are ahead, but we promise the lower case does come off.

    • Push the thin rims of the lower case surrounding the battery compartment in, bending them past the tabs, and then lift up to free that corner of the lower case.

    댓글 쓰기

    • There is a slot on the wall of the battery compartment that locks the lower case in place.

    • Use a small flathead screwdriver to pry out the slot's lower rim and pull up on the lower case to free the slot from the tabs holding it.

    댓글 쓰기

    • Run a spudger along the seam between the lower case and upper case on the front of the computer to free the tabs locking the lower case.

    • Pull up on the lower case and continue to use the spudger as necessary until you hear three distinct clicks.

    댓글 쓰기

    • Continue to run the spudger around the front, right corner.

    • There are two tabs on the port side of the computer, one near the front corner and one near the sound out port.

    댓글 쓰기

    • Once the front and sides of the lower case are free, turn the computer so that the back is facing you.

    • Pull the lower case up and toward you until the back tabs pop free.

    • It may be helpful to jiggle the case up and down.

    댓글 쓰기

    • Remove the small greasy springs with white plastic caps from either side of the battery contacts.

    댓글 쓰기

결론

To reassemble your device, follow these instructions in reverse order.

다른 2명이 해당 안내서를 완성하였습니다.

첨부 문서

iRobot

회원 가입일: 2009년 09월 24일

1 평판

안내서 621개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 0

지난 30일: 7

전체 시간: 4,085