기기를 수리하세요 커뮤니티 상점

iPad 2 Wi-Fi EMC 2415 Heaphone Jack & Front Camera Assembly Replacement

단지 전제 조건
이 안내서는 다른 가이드의 선행 작업으로 사용하기 위한 것입니다. 그 자체로는 불완전합니다.

소개

Internal Prereq.

필요한 것

  1. iPad 2 Wi-Fi EMC 2415 Heaphone Jack & Front Camera Assembly Replacement, Heaphone Jack & Front Camera Assembly: 1 단계, 이미지 1/3 iPad 2 Wi-Fi EMC 2415 Heaphone Jack & Front Camera Assembly Replacement, Heaphone Jack & Front Camera Assembly: 1 단계, 이미지 2/3 iPad 2 Wi-Fi EMC 2415 Heaphone Jack & Front Camera Assembly Replacement, Heaphone Jack & Front Camera Assembly: 1 단계, 이미지 3/3

    • Use the flat end of a plastic opening tool to flip up the retaining flap on the headphone jack and front-facing camera ribbon cable ZIF socket.

    • Be sure you are prying up on the hinged retaining flap, not the socket itself.

    • Run a plastic opening tool underneath the headphone jack and front-facing camera cable to free it from the adhesive attaching the cable to the rear panel.

    • Pull the headphone jack and front-facing camera ribbon cable straight out of its socket on the logic board.

    번역하기

  2. iPad 2 Wi-Fi EMC 2415 Heaphone Jack & Front Camera Assembly Replacement: 2 단계, 이미지 1/1

    • Remove the two 2.9 mm Phillips screws securing the headphone jack to the rear panel.

    번역하기

  3. iPad 2 Wi-Fi EMC 2415 Heaphone Jack & Front Camera Assembly Replacement: 3 단계, 이미지 1/2 iPad 2 Wi-Fi EMC 2415 Heaphone Jack & Front Camera Assembly Replacement: 3 단계, 이미지 2/2

    • Use the edge of a plastic opening tool to peel the tape and the adhesive securing the headphone jack & front camera cables to the rear panel.

    번역하기

  5. iPad 2 Wi-Fi EMC 2415 Heaphone Jack & Front Camera Assembly Replacement: 4 단계, 이미지 1/1

    • Pull the headphone jack away from the top edge of the iPad.

    • Don't try to remove the assembly just yet. The front camera is still stuck to the rear panel.

    번역하기

  6. iPad 2 Wi-Fi EMC 2415 Heaphone Jack & Front Camera Assembly Replacement: 5 단계, 이미지 1/1

    • Lift the headphone jack & front camera cables slightly to access the microphone connector.

    • Use the edge of a plastic opening tool to separate the microphone connector from its socket on the headphone jack & front camera cables.

    번역하기

  7. iPad 2 Wi-Fi EMC 2415 Heaphone Jack & Front Camera Assembly Replacement: 6 단계, 이미지 1/2 iPad 2 Wi-Fi EMC 2415 Heaphone Jack & Front Camera Assembly Replacement: 6 단계, 이미지 2/2

    • Peel the front camera off the foam adhesive securing it to the rear panel.

    • Remove the headphone jack & front camera assembly from the iPad.

    번역하기

  8. iPad 2 Wi-Fi EMC 2415 Heaphone Jack & Front Camera Assembly Replacement: 7 단계, 이미지 1/1

    • Carefully remove the strip of tape covering the front camera cable connector.

    번역하기

  9. iPad 2 Wi-Fi EMC 2415 Heaphone Jack & Front Camera Assembly Replacement: 8 단계, 이미지 1/1

    • Use the edge of a plastic opening tool to disconnect the front camera cable from the headphone jack cable.

    번역하기
결론

To reassemble your device, follow these instructions in reverse order.

작성자

다른 기여자 4명과 함께

Andrew Bookholt

586,236 평판

안내서 619개 작성하였습니다

배지: 47

배지 +44개 더

댓글 0개

댓글 쓰기

조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 0

전체 시간: 512