소개

Prereq for disconnecting battery.

부품

부품은 필요하지 않습니다.

  1. Remove the three 1.3 mm Phillips #00 screws securing the connector shield to the logic board.
    • Remove the three 1.3 mm Phillips #00 screws securing the connector shield to the logic board.

    • Be sure to not substitute these three screws with any other screws, specifically the screws securing the LCD shield plate to the rear case of the iPad. Any slightly longer screws may strip the screw holes and result in irreparable damage to the logic board.

  2. US$100 이상 또는 Pro Tech Toolkit을 포함한 모든 주문의 배송은 무료입니다!

    상점 둘러보기
  3. Use a pair of tweezers to grasp and remove the connector shield from the iPad.
    • Use a pair of tweezers to grasp and remove the connector shield from the iPad.

  4. Use a plastic opening tool to gently pry the battery connector up from its socket on the logic board. Be very careful to only pry up on the battery connector and not on the socket itself. If you pry up on the logic board socket, you may break the connector entirely.
    • Use a plastic opening tool to gently pry the battery connector up from its socket on the logic board.

    • Be very careful to only pry up on the battery connector and not on the socket itself. If you pry up on the logic board socket, you may break the connector entirely.

결론

To reassemble your device, follow these instructions in reverse order.

Andrew Optimus Goldberg

회원 가입일: 2009년 10월 17일

409,151 평판

안내서 412개 작성하였습니다

iFixit iFixit 회원

Community

108 회원들

안내서 8,297개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 4

지난 30일: 5

전체 시간: 314