주요 콘텐츠로 건너뛰기

소개

Prereq only, does not remove antenna, battery is in.

부품

지정된 부품이 없습니다.

  1. Remove the following screws securing the  GPS antenna to the rear case:
    • Remove the following screws securing the GPS antenna to the rear case:

    • One 2.5 mm Phillips #00

    • Two 1.1 mm Phillips #00

    • One 1.2 mm Phillips #00

  2. Use the flat end of a spudger to loosen the foam adhesive holding the GPS antenna to the right speaker. Use the flat end of a spudger to loosen the foam adhesive holding the GPS antenna to the right speaker. Use the flat end of a spudger to loosen the foam adhesive holding the GPS antenna to the right speaker.
    • Use the flat end of a spudger to loosen the foam adhesive holding the GPS antenna to the right speaker.

  3. Gently de-route the antenna cable from the bottom right corner of the rear case. Move the antenna out of the way of the right speaker.
    • Gently de-route the antenna cable from the bottom right corner of the rear case.

    • Move the antenna out of the way of the right speaker.

결론

To reassemble your device, follow these instructions in reverse order.

Walter Galan

611,642 평판

안내서 1,203개 작성하였습니다

댓글 쓰기

조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 0

전체 시간: 40