기기를 수리하세요 커뮤니티 상점

iPhone 4S Speaker Enclosure Assembly Replacement

단지 전제 조건
이 안내서는 다른 가이드의 선행 작업으로 사용하기 위한 것입니다. 그 자체로는 불완전합니다.

소개

Internal prerequisite.

필요한 것

  1. iPhone 4S Speaker Enclosure Assembly Replacement, Speaker Enclosure Assembly: 1 단계, 이미지 1/2 iPhone 4S Speaker Enclosure Assembly Replacement, Speaker Enclosure Assembly: 1 단계, 이미지 2/2

    • Remove the following screws securing the dock connector cable cover to the logic board:

    • One 1.5 mm Phillips screw

    • One 1.2 mm Phillips screw

    • Remove the metal dock connector cable cover.

    편집

  2. iPhone 4S Speaker Enclosure Assembly Replacement: 2 단계, 이미지 1/1

    • Use the edge of a plastic opening tool to pry the dock cable up from its socket on the logic board.

    편집

  3. iPhone 4S Speaker Enclosure Assembly Replacement: 3 단계, 이미지 1/1

    • Peel the dock connector cable off the adhesive securing it to the logic board and the side of the speaker enclosure.

    편집

  5. iPhone 4S Speaker Enclosure Assembly Replacement: 4 단계, 이미지 1/2 iPhone 4S Speaker Enclosure Assembly Replacement: 4 단계, 이미지 2/2

    • Use the edge of a plastic opening tool to pry the cellular antenna cable up from its socket on the logic board.

    • De-route the cellular antenna cable out from under the metal fingers attached to the logic board.

    편집

  6. iPhone 4S Speaker Enclosure Assembly Replacement: 5 단계, 이미지 1/1

    • Remove the two 2.4 mm Phillips screws securing the speaker enclosure assembly to the outer case.

    편집

  7. iPhone 4S Speaker Enclosure Assembly Replacement: 6 단계, 이미지 1/1

    • Remove the small black spacer that was under the Phillips screw near the vibrator.

    편집

  8. iPhone 4S Speaker Enclosure Assembly Replacement: 7 단계, 이미지 1/3 iPhone 4S Speaker Enclosure Assembly Replacement: 7 단계, 이미지 2/3 iPhone 4S Speaker Enclosure Assembly Replacement: 7 단계, 이미지 3/3

    • Use a plastic opening tool to lift the speaker enclosure assembly out of the case, being sure not to damage the EMI fingers on the attached Wi-Fi antenna.

    • Remove the speaker enclosure assembly.

    • Before reinstalling the speaker enclosure assembly's screws, be sure the Wi-Fi grounding fingers are installed below the lip in the iPhone's metal case as seen in the third picture.

    • Before reassembly, be sure to clean all metal-to-metal contact points between the grounding fingers of the Wi-Fi antenna and the case of the iPhone with a de-greaser such as windex or isopropyl alcohol. The oils on your fingers have the potential to cause wireless interference issues.

    편집
결론

To reassemble your device, follow these instructions in reverse order.

다른 한 분이 해당 안내서를 완성하였습니다.

작성자

다른 기여자 5명과 함께

Walter Galan

694,573 평판

안내서 1,203개 작성하였습니다

배지: 54

배지 +51개 더

댓글 0개

댓글 쓰기

조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 0

전체 시간: 726